Troubleshooting Guide
This page aims to list common problems people have with the plugin. Please read it before opening issues.
This is going to be an ever-evolving page, as I learn of common issues people identify when setting up the plugin.
Got something to contribute? You can send a PR to edit this page, just click the 'Edit on Github' button. All contributions are welcome!
LEDs flicker and change colour loads
Check you have a common ground between an external power supply, and the Pi. See more (including an example video) in the issue opened here
The colours of my LEDs are wrong
Make sure you have the correct order of RGB strip selected in the strip settings. You can use the LED Strip test to help debug this issue quickly.
Can't find the plugin after installed
Make sure you restart the OctoPrint server, and reload the web interface. You should see the wizard pop up, or the light/torch icon in the navbar.
I restored an OctoPrint backup to a new install, but the LEDs no longer work?
It is likely that the OS level config is incorrect. To fix this, please head to the OS Configuration Test section (under 'Utilities') to run a test and fix the configuration. See the OS Configuration Test docs.
Unable to initialize SPI
If you get the error:
From the plugin_ws281x_led_status_debug.log then it likely means that you have some extra peripherals attached to your Pi, that are taking up the SPI channels, therefore conflicting with the plugin's use of SPI.
Specific to this Elecrow 5 inch HDMI touchscreen
A user reported that SPI failed to initialise with the above screen, however commenting out the lines the guide asked you to enter meant that both the screen and LEDs could work at the same time.
No LED output on a Raspberry Pi 4B (rev 1.4), and the log says 'Unsupported board'
The dependency that this plugin relies on was not updated to add support for these boards as of the last release of the plugin. Please see this issue for instructions of how to fix it.
Little/no LED output when not using a level shifter
Some strips do not like 3.3V signals, and if you do use 3.3v (without a level shifter) then please keep the wires to the LEDs fairly short to avoid voltage drop.
Random flickering of LEDs, unstable signal
Adding a 470Ω resistor in the signal line can help. Some guides recommend this, in my experience it is not always required. Worth a try if you have unstable signal to the LEDs. Link to issue.
More unstable signal fixes
Mixed reports that using a sacrificial LED on a short wire (to avoid voltage drop) can be beneficial for the LED strip. See this Hackaday article for more details. This solution is untested, only linked because it might be useful.
Last updated